EUNOIA topFIX is a basic one-component dry type of construction adhesive, made of mineral fillers, additives, hydraulic and synthetic binders. EUNOIA topFIX base is intended exclusively for gluing styrofoam boards with mandatory doweling (6 pcs/m²). It is not intended for mesh reinforcement, nor as a final layer.
 Method of use: The surface on which the glue is applied must be solid, dry, free of grease and without any oil residues or old coatings. EUNOIA topFIX base is prepared by adding 200-250 g of water to 1 kg of material. Mix the mixture for 3-5 minutes until complete homogenization. Leave the prepared material to stand for approx. 10 minutes, then mix the glue once more, after which it is ready for use. Use the prepared glue within two hours. EUNOIA topFIX base is applied manually with a steel trowel in the middle and along the edges at an angle of 45 degrees from the outside (glue coverage min. 40%), and gently press the panel onto the wall. The glue can be applied mechanically to the panel in strips along the edges and 2-3 stripes in the middle. Glue must never get between the joints of the panels, because thermal bridges are made in this way. Fill joints up to 2 mm with PU foam for styrofoam, and over 2 mm with styrofoam strips. Opening time is about 20 minutes.
 Operating temperature: The optimal operating temperature is from +10°C to +30°C. It must not be used below +5°C, nor in strong sun, wind, fog or rain. In optimal conditions, freshly treated surfaces should be protected from atmospheric influences for at least 24 hours.
 Consumption: 4-5 kg/m2, depending on the condition of the wall surface.
 Shelf life and storage: 12 months from the production date indicated on the packaging. Store in the original, well-closed and undamaged packaging in a dry and ventilated room, according to the conditions prescribed for cement storage.