EUNOIA topFIX hobby is a one-component dry type of construction adhesive, made of mineral fillers, additives, hydraulic and synthetic binders. EUNOIA topFIX hobby is intended for gluing styrofoam on all types of mineral substrates, for a reinforced layer on styrofoam plates as well as for gluing ceramics in interior rooms.
 Method of use: The substrate on which the glue is applied must be firm, dry, free of grease and without any residues of oil or old coatings. EUNOIA topFIX hobby is prepared by adding 200-250 g of water to 1 kg of material. Mix the mixture for 3-5 minutes until complete homogenization. Leave the prepared material to stand for approx. 10 minutes, then mix the glue once more, after which it is ready for use. Use the prepared glue within two hours. Eunoia topFIX hobby is applied manually with a steel trowel in the middle and along the edges at an angle of 45 degrees from the outside (glue coverage min. 40%), and gently press the panel on the wall. 2-3 stripes down the middle. Glue must never get between the joints of the panels, because thermal bridges are made in this way. Fill joints up to 2 mm with PU foam for styrofoam and over 2 mm with styrofoam strips. Opening time is about 20 minutes. Place the reinforcing mesh by pressing into the layer of applied EUNOIA topFIX hobby glue in a thickness of 2-3 mm, with an overlap of 10 cm, and then level the entire surface with EUNOIA topFIX hobby glue. The total thickness of the applied EUNOIA topFIX hobby should be at least 4 mm. When applying for gluing ceramics, a metal toothed planer is used. Press the tiles into the adhesive and move them slightly. The position of the tile can be adjusted for 10 minutes without affecting the stickiness. After the glue has hardened, wash the tiles with water and grout the joints with grout.
 Operating temperature: The optimal operating temperature is from +10°C to +30°C. It must not be used below +5°C, nor in strong sun, wind, fog or rain. In optimal conditions, freshly treated surfaces should be protected from atmospheric influences for at least 24 hours.
 Consumption: 4-5 kg/m2 for gluing, depending on the condition of the wall surface; 4-5 kg/m2 for reinforcement.